How much do you drive in a year? What kind of car are you looking at?
For the average driver, a 120V (normal) outlet on a smaller car is actually perfectly fine most of the time. If you think you might get a bigger car, or multiple EVs, you may want to look into a level 2 setup. And while you’re at it, use thicker wires so you can run more power through it. But don’t feel like you have to go overboard. I think the sweet “buy once, cry once, hard to come up with a situation where this isn’t enough” number is a 50 amp 240V circuit running a 40A charge cord (always charge at 80% of your circuit rating, max).
But if your panel can’t take it or you want to do it cheaper or whatever, a 20A 240V circuit is on the lower end of the level 2 spectrum and it can still do a lot… Like, more than double that “average driver” amount for level 1. And here’s the fun part: everyone is so afraid of 240V and think it takes special wiring or whatever. It really doesn’t. I’ve got a 240V air compressor outlet on a 20A circuit, just like what I suggested a minute ago. It uses the exact same wiring as the 120V next to it. The only difference? It’s connected to two “opposing” hots with a double breaker (not terribly more expensive) rather than a single hot on a single breaker plus a neutral as you’d see on 120V. All you need to do is wrap the white wire (usually neutral) with a colored (not green, that’s ground) electrical tape to indicate that it carries current. Do it on both sides. Easy peasy, up to code, and uses really affordable wiring.
How much do you drive in a year? What kind of car are you looking at?
For the average driver, a 120V (normal) outlet on a smaller car is actually perfectly fine most of the time. If you think you might get a bigger car, or multiple EVs, you may want to look into a level 2 setup. And while you’re at it, use thicker wires so you can run more power through it. But don’t feel like you have to go overboard. I think the sweet “buy once, cry once, hard to come up with a situation where this isn’t enough” number is a 50 amp 240V circuit running a 40A charge cord (always charge at 80% of your circuit rating, max).
But if your panel can’t take it or you want to do it cheaper or whatever, a 20A 240V circuit is on the lower end of the level 2 spectrum and it can still do a lot… Like, more than double that “average driver” amount for level 1. And here’s the fun part: everyone is so afraid of 240V and think it takes special wiring or whatever. It really doesn’t. I’ve got a 240V air compressor outlet on a 20A circuit, just like what I suggested a minute ago. It uses the exact same wiring as the 120V next to it. The only difference? It’s connected to two “opposing” hots with a double breaker (not terribly more expensive) rather than a single hot on a single breaker plus a neutral as you’d see on 120V. All you need to do is wrap the white wire (usually neutral) with a colored (not green, that’s ground) electrical tape to indicate that it carries current. Do it on both sides. Easy peasy, up to code, and uses really affordable wiring.